EZ-press One Step qRT-PCR Kit (ROX1 plus)

Introduction

The EZBioscience^® EZ-press One Step qRT-PCR Kit (ROX1 plus) is a one-step kit to quantify RNA using SYBR Green I. With the exception of primers and template, this kit contains in two vials all the components required to perform rapid, sensitive and reproducible qRT-PCR.

10× One Step qRT Enzyme Mix contains M-MLV (RNase H-) reverse transcriptase, RNase Inhibitor, Hot Start DNA Polymerase; 2× One Step qRT Buffer contains SYBR Green I, dNTPs, optimized buffer and ROX1.

The M-MLV Reverse Transcriptase, which is an RNA-dependent DNA polymerase with a significantly attenuated RNase H activity, can synthesize cDNA at a temperature range of 42°C to 60°C and is inactivated during the activation step of the Hot Start DNA Polymerase.

RNase inhibitor can protect RNA templates from degradation.

This buffer has been optimized to allow both reverse transcription and PCR amplification to occur in the same reaction across a wide range of templates.

Hot Start DNA Polymerase requires an activation step at 95°C for 5 minutes, which prevents non-specific amplification during cDNA synthesis.

Components

*1: Contain reverse transcriptase, RNase Inhibitor, Hot Start DNA Polymerase.

*2: Contain SYBR Green I, dNTPs, optimized buffer and ROX1.

The ROX1 premixed is used to rectify the error of fluorescence signals between different wells.

Storage

The kit should be stored at -20°C and protected from light. Avoid repeated freeze thawing. The quality of this product can be guaranteed for 18 months under recommended storage conditions.

Notice

Appropriate real-time PCR instruments for this kit are as follows:

Representative Results

Figure1. GAPDH mRNA expression level in serially diluted RNA from Lentivirus were detected. The amplification plots above indicate that the target gene could be amplified efficiently and specifically.

For detailed information, please check the product manual.